SERBOI, Claudia; VELICU, Stefan; DARNIS, Philippe; LAHEURTE, Raynald; IONESCU, Cristian

doi:10.4028/www.scientific.net/amm.186.200

Metadatos

Mostrar el registro completo del ítem

Licencia de uso del documento

SERBOI, Claudia

VELICU, Stefan

DARNIS, Philippe

Institut de Mécanique et d'Ingénierie [I2M]

Idioma

Article de revue

Este ítem está publicado en

Applied Mechanics and Materials. 2012-06-01, vol. 186, p. 200-207

Resumen en inglés

Titanium and its alloys have found wide application in the aerospace, biomedical and automotive industries owing to their good strength-to weight ratio and high corrosion resistance. However, these alloys have very poor machinability, which is attributed to their inherent high strength maintained at elevated temperature and low thermal conductivity leading to high cutting temperatures. This paper presents the findings of an experimental investigation into the effects of cutting speed, feed rate and depth of cut when milling titanium alloy Ti-6Al-4V. The cutting forces were the response variables investigated. This experimental investigation is translated into a mathematical model of cutting forces designed on the basis of the results obtained from this research.< Leer menos

Palabras clave en inglés

Cutting Force

Machinability

Machining Parameters

Titanium Alloy

Metadatos

Compartir este ítem

Licencia de uso del documento

The Preliminary Study Of Machinability During Milling Of Titanium Alloy (Ti-6Al-4V)

Idioma

Este ítem está publicado en

Resumen en inglés

Palabras clave en inglés

URI

DOI

Centros de investigación