SERBOI, Claudia; VELICU, Stefan; DARNIS, Philippe; LAHEURTE, Raynald; IONESCU, Cristian

doi:10.4028/www.scientific.net/amm.186.200

Métadonnées

Afficher la notice complète

Licence d’utilisation du document

SERBOI, Claudia

VELICU, Stefan

DARNIS, Philippe

Institut de Mécanique et d'Ingénierie [I2M]

Langue

Article de revue

Ce document a été publié dans

Applied Mechanics and Materials. 2012-06-01, vol. 186, p. 200-207

Résumé en anglais

Titanium and its alloys have found wide application in the aerospace, biomedical and automotive industries owing to their good strength-to weight ratio and high corrosion resistance. However, these alloys have very poor machinability, which is attributed to their inherent high strength maintained at elevated temperature and low thermal conductivity leading to high cutting temperatures. This paper presents the findings of an experimental investigation into the effects of cutting speed, feed rate and depth of cut when milling titanium alloy Ti-6Al-4V. The cutting forces were the response variables investigated. This experimental investigation is translated into a mathematical model of cutting forces designed on the basis of the results obtained from this research.< Réduire

Mots clés en anglais

Cutting Force

Machinability

Machining Parameters

Titanium Alloy

Métadonnées

Partager cette publication !

Licence d’utilisation du document

The Preliminary Study Of Machinability During Milling Of Titanium Alloy (Ti-6Al-4V)

Langue

Ce document a été publié dans

Résumé en anglais

Mots clés en anglais

URI

DOI

Unités de recherche