Compression heating of selected pressure transmitting fluids and liquid foods during high hydrostatic pressure treatment
BUZRUL, Sencer
Food Engineering Department
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]
See more >
Food Engineering Department
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]
BUZRUL, Sencer
Food Engineering Department
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]
< Reduce
Food Engineering Department
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]
Language
en
Article de revue
This item was published in
Journal of Food Engineering. 2008, vol. 85, n° 3, p. 466-472
Elsevier
English Abstract
Three pressure transmitting fluids (water, ethylene glycol, and ethanol) and three liquid foods (orange juice, whole, and skim milk) were pressurized at 100–400 MPa and at 5, 20 and 35 °C, using different compression rates ...Read more >
Three pressure transmitting fluids (water, ethylene glycol, and ethanol) and three liquid foods (orange juice, whole, and skim milk) were pressurized at 100–400 MPa and at 5, 20 and 35 °C, using different compression rates (100, 200, and 300 MPa/min) to evaluate the adiabatic heating phenomena during high hydrostatic pressure (HHP) processing. A pressure vessel (3 L volume) in which liquid foods could be introduced directly was used to demonstrate the compression heating phenomena in large-scale commercial conditions. The highest and second highest compression heating values were observed for ethanol and ethylene glycol, respectively. Orange juice, whole, and skim milk showed similar compression heating values with water. The results revealed that as the initial temperature of the samples increased, compression heating values also increased. In general, as the pressure level increased, the temperature increase per 100 MPa decreased only for ethanol and ethylene glycol. The compression rate also had an impact on the compression heating values of ethanol and ethylene glycol. However, water and liquid foods (that contained high amount of water) were not affected by the compression rate within the range studied (100–300 MPa/min)...Read less <
English Keywords
High hydrostatic pressure
Compression heating
Pressure transmitting fluids
Response surface model
Origin
Hal imported