BUROS, Camille; VIOT, Philippe; HAZELL, Paul J.; WANG, Hongxu; LARTIGAU, Julie

doi:10.1016/j.ijimpeng.2025.105265

Metadatos

Mostrar el registro completo del ítem

Licencia de uso del documento

BUROS, Camille
ESTIA - Institute of technology [ESTIA]

VIOT, Philippe

HAZELL, Paul J.

Idioma

Article de revue

Este ítem está publicado en

International Journal of Impact Engineering. 2025-07, vol. 201, p. 105265

Resumen en inglés

The out-of-plane compressive behaviour of three types of architected structures subjected to quasi-static and dynamic indentation was investigated in this paper. The effects of filling a pattern - with three unit-cell patterns and three levels of cell wall waviness - and velocities are characterized through experiments at low (10 mm/min) and high-speed testing (around 300 m/s). The metallic architected structures of interest are extruded in two-dimensions through Directed Energy Deposition – Laser Powder (DED-LP) technology. This work is focused on the energy absorption capacities of architected structures when indented. In quasi-static, the results showed no effect of the cell walls waviness on the energy absorption capacity of the structures. However, different deformation mechanisms were observed depending on the unit-cell pattern, showing an effect of unit-cell pattern on energy absorption capacities. On the contrary, in dynamic enhanced absorption capacities were observed with higher level of cell walls waviness. Finally, the cross-sectional view of the structures after indentation were analyzed to observe the failure mechanisms.< Leer menos

Palabras clave en inglés

Architected structures

Metal additive manufacturing

Indentation

Dynamic impact

Energy absorption

Static

Metadatos

Compartir este ítem

Licencia de uso del documento

Effect of filling pattern on the response of 316L additively manufactured architected structures subjected to dynamic indentation

Idioma

Este ítem está publicado en

Resumen en inglés

Palabras clave en inglés

URI

DOI

Centros de investigación