Flash Spark Plasma Sintering of 3YSZ: Modified sintering pathway and impact on grain boundary formation
HÉRISSON DE BEAUVOIR, Thomas
Centre interuniversitaire de recherche et d'ingénierie des matériaux [CIRIMAT]
Leer más >
Centre interuniversitaire de recherche et d'ingénierie des matériaux [CIRIMAT]
HÉRISSON DE BEAUVOIR, Thomas
Centre interuniversitaire de recherche et d'ingénierie des matériaux [CIRIMAT]
< Leer menos
Centre interuniversitaire de recherche et d'ingénierie des matériaux [CIRIMAT]
Idioma
en
Article de revue
Este ítem está publicado en
Journal of the European Ceramic Society. 2021, vol. 41, n° 15, p. 7762-7770
Elsevier
Resumen en inglés
Yttria stabilized zirconia (3 mol% YSZ) ceramics were prepared by Flash-SPS, while allowing high heating rates up to 200°C/s, which led to the extremely fast densification within a few seconds. The high heating rates had ...Leer más >
Yttria stabilized zirconia (3 mol% YSZ) ceramics were prepared by Flash-SPS, while allowing high heating rates up to 200°C/s, which led to the extremely fast densification within a few seconds. The high heating rates had strong impact on sintering mechanisms, in terms of densification and grain growth. While the specimens ended with 5 to 15 vol% porosity and limited grain growth (< 350 nm), their hardness is higher than fully dense counterpart SPSed ceramics. Using the sintering trajectories, microstructural observations, and impedance spectroscopy, we highlight altered sintering mechanism which resulted in very thin grain boundaries compared to SPS. It appears that densification is largely advanced at grain boundary interfaces, with no residual nano-pores at the grain junctions, where some pores with size comparable to grain size were present. This opens up opportunities for the fabrication of porous lightweight ceramics with good mechanical properties.< Leer menos
Palabras clave en inglés
Flash-SPS
Grain boundary
Zirconia
Orígen
Importado de HalCentros de investigación