WANTZ, G.; HIRSCH, L.; HUBY, N.; VIGNAU, L.; SILVAIN, Jean-François; BARRIÉRE, A. S.; PARNEIX, J. P.

doi:10.1016/j.tsf.2005.03.022

Métadonnées

Licence d’utilisation du document

WANTZ, G.
Laboratoire de physique des interactions ondes matières [LPIOM]
Laboratoire de l'intégration, du matériau au système [IMS]

HIRSCH, L.
Laboratoire de l'intégration, du matériau au système [IMS]
Laboratoire d'études de l'intégration des composants et systèmes électroniques [IXL]

HUBY, N.
Laboratoire de physique des interactions ondes matières [LPIOM]
Laboratoire de l'intégration, du matériau au système [IMS]
Laboratoire d'études de l'intégration des composants et systèmes électroniques [IXL]

Langue

Article de revue

Ce document a été publié dans

Thin Solid Films. 2005, vol. 485, n° 1-2, p. 247-251

Elsevier

Résumé en anglais

This paper reports on performance enhancement of polymer light-emitting diodes (PLEDs) based on poly(2,5-bis(3′,7′-dimethyl-octyloxy)1,4-phenylene-vinylene) (BDMO-PPV) after Indium Tin Oxide (ITO) pre-treatment. Diluted aqua regia surface treatments of ITO substrates were investigated before PLEDs manufacturing. The correlation between ITO surface morphology and the properties of devices were discussed. The residual roughness, the global ITO thickness and developed anodic active area were found extremely dependent on treatment time. The performances of the ITO/BDMO-PPV/Ca/Al diodes were improved. With long treatments, the roughness was dramatically increased and poor PLEDs performances were achieved. The incorporation of a conducting polymer layer, poly(3,4-ethylene dioxythiophene) doped with polystyrene sulfonate, between the ITO layer and the emissive polymer, was also studied. With this buffer layer, no effect of the acidic treatment was observed on luminance–voltage characteristics and low turn-on voltage devices were made.< Réduire

Mots clés en anglais

Polymer light emitting diode

Indium tin oxide

Atomic force microscopy

Rutherford backscattering spectroscopy

Métadonnées

Licence d’utilisation du document

Correlation between the Indium Tin Oxide morphology and the performances of polymer light-emitting diodes

Langue

Ce document a été publié dans

Résumé en anglais

Mots clés en anglais

DOI

Origine

Unités de recherche