CHAMBON, Sylvain; DERUE, Lionel; LAHAYE, Michel; PAVAGEAU, Bertrand; HIRSCH, Lionel; WANTZ, Guillaume

doi:10.3390/ma5122521

Métadonnées

Afficher la notice complète

Licence d’utilisation du document

CHAMBON, Sylvain
ELORGA

DERUE, Lionel
Laboratoire de l'intégration, du matériau au système [IMS]

LAHAYE, Michel
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]

Langue

Article de revue

Ce document a été publié dans

Materials. 2012-11-27, vol. 5, n° 12, p. 2521-2536

MDPI

Résumé en anglais

Several parameters of the fabrication process of inverted polymer bulk heterojunction solar cells based on titanium oxide as an electron selective layer and molybdenum oxide as a hole selective layer were tested in order to achieve efficient organic photovoltaic solar cells. Thermal annealing treatment is a common process to achieve optimum morphology, but it proved to be damageable for the performance of this kind of inverted solar cells. We demonstrate using Auger analysis combined with argon etching that diffusion of species occurs from the MoO3/Ag top layers into the active layer upon thermal annealing. In order to achieve efficient devices, the morphology of the bulk heterojunction was then manipulated using the solvent annealing technique as an alternative to thermal annealing. The influence of the MoO3 thickness was studied on inverted, as well as direct, structure. It appeared that only 1 nm-thick MoO3 is enough to exhibit highly efficient devices (PCE = 3.8%) and that increasing the thickness up to 15 nm does not change the device performance.< Réduire

Métadonnées

Licence d’utilisation du document

MoO3 Thickness, Thermal Annealing and Solvent Annealing Effects on Inverted and Direct Polymer Photovoltaic Solar Cells

Langue

Ce document a été publié dans

Résumé en anglais

DOI

Origine

Unités de recherche