JIANG, Li Jia; ZHOU, Yun Shen; XIONG, Wei; GAO, Yang; HUANG, Xi; JIANG, Lan; BALDACCHINI, Tommaso; SILVAIN, Jean-François; LU, Yong Feng

doi:10.1364/OL.39.003034

Métadonnées

Afficher la notice complète

Licence d’utilisation du document

JIANG, Li Jia
Department of Electrical Engineering

ZHOU, Yun Shen
Department of Electrical Engineering

XIONG, Wei
Department of Electrical Engineering

Langue

Article de revue

Ce document a été publié dans

Optics Express. 2014, vol. 39, n° 10, p. 3034-3037

Optical Society of America - OSA Publishing

Résumé en anglais

In this study, the degree of conversion (DC) of an acrylic-based resin (IP-L 780) in two-photon polymerization (TPP) is systematically investigated via Raman microspectroscopy. A quantitative relationship between TPP laser parameters and the DC of the resin is established. Nonlinear increase in DC with increased laser average power is observed. The resin DC is more sensitive to the laser average power than the laser writing speed. Nanoindentation was employed to correlate the results obtained from Raman microspectroscopy with the mechanical properties of microstructures fabricated by TPP. At constant writing speeds, microstructures fabricated with high laser average powers possess high hardness and high reduced Young's modulus (RYM), indicating high DCs. The results are in line with high DCs measured under the same TPP parameters in Raman microspectroscopy. Raman microspectroscopy is proved to be an effective, rapid, and nondestructive method characterizing microstructures fabrication by TPP.< Réduire

Métadonnées

Licence d’utilisation du document

Two-photon polymerization: investigation of chemical and mechanical properties of resins using Raman microspectroscopy

Langue

Ce document a été publié dans

Résumé en anglais

DOI

Origine

Unités de recherche