Afficher la notice abrégée

hal.structure.identifierLaboratoire d'Acoustique de l'Université du Mans [LAUM]
dc.contributor.authorCHIGAREV, Nikolay
dc.contributor.authorSAVI, E. L.
hal.structure.identifierEquipe Ultrasons Lasers
dc.contributor.authorRAETZ, Samuel
hal.structure.identifierLaboratoire d'Acoustique de l'Université du Mans [LAUM]
dc.contributor.authorTOURNAT, Vincent
hal.structure.identifierLaboratoire de physique de l'état condensé [LPEC]
dc.contributor.authorBULOU, Alain
hal.structure.identifierLaboratoire des Sciences des Procédés et des Matériaux [LSPM]
dc.contributor.authorZERR, Andreas
dc.contributor.authorGOUSSEV, Vitali
dc.date.accessioned2021-05-14T09:39:56Z
dc.date.available2021-05-14T09:39:56Z
dc.date.created2019-09-01
dc.date.conference2019-09-01
dc.identifier.urihttps://oskar-bordeaux.fr/handle/20.500.12278/76534
dc.description.abstractEnThe time-domain Brillouin scattering (TDBS) is a non-destructive opto-acousto-optic pump-probe technique [1] which allows the study of a variety of transparent materials [2]. In this technique, a femtosecond pump laser pulse, absorbed by an optoacoustic transducer, emits a picosecond acoustic pulse into the sample. The width of this pulse is in nanometric spatial scale. The acoustic pulse reflects a time-delayed probe laser pulse generated by the same or another femtosecond laser. The detected transient reflectivity signal is a result of the interference at the photodetector of probe light reflected by stationary surfaces/interfaces of the sample and of probe light reflected by acoustic pulse. It contains the information on the properties of the material in a time-dependent spatially localized position of the acoustic pulse. Therefore, the technique allows imaging of materials along the acoustic pulse propagation path with a spatial resolution better than optical one. Two dimensional TDBS imaging has been earlier applied for revealing the texture of solid H 2 O [3] and Ar [4], the phase transitions [5] and the pressure dependences of single crystal elastic moduli C ij (P) in water ice up to 82 GPa [6]. We report here the extension of the TDBS technique to the 3D imaging of transparent materials compressed in a DAC. To accelerate the data acquisition and thus to make 3D imaging possible in a reasonable time, we have applied an ultrafast laser technique based on an asynchronous optical sampling (ASOPS). In the ASOPS technique, the time delay between the pump and the probe pulses is controlled electronically by an offset of the repetition rate frequency of two lasers without the use of a mechanical optical delay line. The TBDS experiments described here have been performed using an ASOPS-based picosecond acoustic microscope (JAX-M1, NETA, France). First, TBDS experiments have been realised on water ice compressed in a DAC to 2.1 GPa. An iron plate of ~40 µm thickness and ~110 µm in diameter has been used as an optoacoustic generator. The diameter of the pump and probe laser beams at the surface of the generator was ~1.4 µm. Irradiated by pump laser pulse at 515 nm wavelength, the optoacoustic generator emits picosecond acoustic pulses into the 14.5 µm layer of water ice [5]. The obtained 3D distribution of the Brillouin frequencies in the sample volume with dimensions of 40×40×10 µm 3 is represented in Figure 1 in form of its 3 cross sectional slices. The slices correspond to the average delay times of 0.11 ns, 0.36 ns and 0.74 ns , corresponding to the average depths around Figure 1. 2D maps of the Brillouin frequencies distribution in the 40×40 µm 2 cross sections of the tested ice volume at 2.1 GPa for three shifting time slices. The red line highlights one of the lateral regions with important variations of the Brillouin frequency as a function of the axial distance from the generator, which increases with time delay. 0.6 µm, 2 µm, and 4 µm, respectively. The time durations of the presented cross sectional slices are 0.08 ns, 0.08 ns and 0.14 ns, corresponding to spatial thicknesses of approximately 400 nm, 400 nm, and 750 nm, respectively. The lateral resolution within each cross-section was 2 µm. The total time, needed for the collection of this 3D distribution, was of about 2 hours. The maps of the Brillouin frequencies have been obtained using a time-frequency analysis based on the synchronous detection principle [6]. It is worth noting that while each cross sectional time slice has a constant duration for any lateral coordinate, its spatial thickness and the average axial depth are different in different lateral points because acoustic waves propagate with different velocities in different lateral points. The estimations demonstrate that the highest and the lowest detected Brillouin frequencies correspond to the ice VII,
dc.language.isoen
dc.source.title57th European High Pressure Research Group (EHPRG) Meeting on High Pressure Science and Technology (Prague, Czech Republic; September 1-6, 2019) – Program & Abstracts
dc.subject.enasynchronous optical sampling
dc.subject.enpump-probe
dc.subject.enH 2
dc.title.enThree-dimensional imaging of inhomogeneities in transparent solids compressed in a DAC by time-domain Brillouin scattering
dc.typeCommunication dans un congrès avec actes
dc.subject.halSciences de l'ingénieur [physics]/Acoustique [physics.class-ph]
dc.subject.halPhysique [physics]/Matière Condensée [cond-mat]/Science des matériaux [cond-mat.mtrl-sci]
dc.subject.halPhysique [physics]/Mécanique [physics]/Mécanique des solides [physics.class-ph]
bordeaux.hal.laboratoriesInstitut de Mécanique et d’Ingénierie de Bordeaux (I2M) - UMR 5295*
bordeaux.institutionUniversité de Bordeaux
bordeaux.institutionBordeaux INP
bordeaux.institutionCNRS
bordeaux.institutionINRAE
bordeaux.institutionArts et Métiers
bordeaux.countryCZ
bordeaux.title.proceeding57th European High Pressure Research Group (EHPRG) Meeting on High Pressure Science and Technology
bordeaux.conference.cityPrague
bordeaux.peerReviewednon
hal.identifierhal-02352695
hal.version1
hal.origin.linkhttps://hal.archives-ouvertes.fr//hal-02352695v1
bordeaux.COinSctx_ver=Z39.88-2004&rft_val_fmt=info:ofi/fmt:kev:mtx:journal&rft.btitle=57th%20European%20High%20Pressure%20Research%20Group%20(EHPRG)%20Meeting%20on%20High%20Pressure%20Science%20and%20Technology%20(Prague,%20Czech%20Republic;%20September%2&rft.au=CHIGAREV,%20Nikolay&SAVI,%20E.%20L.&RAETZ,%20Samuel&TOURNAT,%20Vincent&BULOU,%20Alain&rft.genre=proceeding


Fichier(s) constituant ce document

FichiersTailleFormatVue

Il n'y a pas de fichiers associés à ce document.

Ce document figure dans la(les) collection(s) suivante(s)

Afficher la notice abrégée