High-power and low-intensity noise laser at 1064nm
GUIRAUD, Germain
Azur Light Systems.
Azur Light Systems
Laboratoire Photonique, Numérique et Nanosciences [LP2N]
Azur Light Systems.
Azur Light Systems
Laboratoire Photonique, Numérique et Nanosciences [LP2N]
GUIRAUD, Germain
Azur Light Systems.
Azur Light Systems
Laboratoire Photonique, Numérique et Nanosciences [LP2N]
< Leer menos
Azur Light Systems.
Azur Light Systems
Laboratoire Photonique, Numérique et Nanosciences [LP2N]
Idioma
en
Article de revue
Este ítem está publicado en
Optics Letters. 2016, vol. 41, n° 17, p. 4040-4043
Optical Society of America - OSA Publishing
Resumen en inglés
We have developed a single-frequency, narrow-linewidth (Δν < 50 kHz) laser operating at 1064 nm with a high output power (50 W). The laser is based on an ytterbium-doped fiber master oscillator power amplifier architecture ...Leer más >
We have developed a single-frequency, narrow-linewidth (Δν < 50 kHz) laser operating at 1064 nm with a high output power (50 W). The laser is based on an ytterbium-doped fiber master oscillator power amplifier architecture with an output beam at the diffraction limit. An output power of 50 W is obtained with two amplification stages using a 50 mW diode laser seeder. We have carefully studied the relative intensity noise at each amplification stage. The detrimental effect due to stimulated Brillouin scattering on residual amplitude noise has been observed on the high-power booster stage. After careful optimization, this laser exhibits low intensity noise with a RMS value equal to 0.012% (1 kHz/10 MHz) at 50 W.< Leer menos
Palabras clave en inglés
Laser
Low Noise
High power amplifier
Orígen
Importado de HalCentros de investigación