SILVAIN, Jean-François; BOBET, Jean-Louis; HEINTZ, Jean-Marc

doi:10.1016/S1359-835X(02)00153-7

Metadatos

Mostrar el registro completo del ítem

Licencia de uso del documento

SILVAIN, Jean-François
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]

BOBET, Jean-Louis
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]

HEINTZ, Jean-Marc
Institut de Chimie de la Matière Condensée de Bordeaux [ICMCB]

Idioma

Article de revue

Este ítem está publicado en

Composites Part A: Applied Science and Manufacturing. 2002, vol. 33, n° 10, p. 1387-1390

Elsevier

Resumen en inglés

This work has been initiated in order to find new routes for the preparation of 3D interconnected ceramic-metal composites, usually obtained by direct metal oxidation or liquid infiltration of a ceramic preform. The system under investigation is the alumina-copper system. The key point of this new route was the preparation of very fine composite powders, which allowed the material to be densified by natural sintering. The first part of the presentation deals with the preparation of the composite powders, which was achieved using an electroless process. Influence of experimental parameters controlling the deposition of a copper layer on a sub-micronic alumina powder was investigated. The second part deals with the processing of the composite. A statistical design methodology was applied to determine the main parameters controlling the shrinkage. For some conditions, a new in situ Cu-CuAlO2 composite is formed, which presents an interesting microstructure with CuAlO2 acicular grains.< Leer menos

Palabras clave en inglés

Sintering

Al2O3-Cu

Composite powders

Electroless process

Metadatos

Licencia de uso del documento

Electroless deposition of copper on to alumina sub-micronic powders and sintering

Idioma

Este ítem está publicado en

Resumen en inglés

Palabras clave en inglés

DOI

Orígen

Centros de investigación